Comtrol ES7110-VB - Manual (Page 10)

10 - RocketLinx ES7110 and ES7110-VB User Guide: 2000552 Rev. C Mounting the RocketLinx ES7110
Hardware Installation
Mounting the RocketLinx ES7110
The RocketLinx ES7110 can be mounted on a DIN rail or on a wall panel. The DIN rail clip is already attached to the
RocketLinx ES7110 when packaged.
Note: The RocketLinx ES7110 will disperse heat through the metal case during PoE port operation. The RocketLinx ES7110
should be installed and mounted onto a panel which provides good heat dispersion.
You can use this procedure to mount the ES7110 on a DIN rail.
1. Insert the upper end of DIN rail clip into the back of DIN rail track from its
upper side.
2. Lightly push the bottom of DIN rail clip into the track.
3. Ensure the DIN rail clip is tightly attached on the track.
4. To remove the RocketLinx ES7110 from the track, reverse the steps above.
You can use this procedure to mount the ES7110 on the wall:
1. Snap the DIN rail plate into the track.
2. Attach the ES7110 to the wall using the mounting screws.
Connecting the Ethernet Ports
You can use the following information to connect standard Ethernet cables between the ES7110 Ethernet ports and the network
nodes.
• Ports G1 and G2 are Gigabit Ethernet uplink ports that support 10BASE-T, 100BASE-TX, and 1000BASE-TX.
• Ports 1-8 are Fast Ethernet 10/100BASE-TX PoE ports that are IEEE 802.3af (PoE) compliant (15.4W maximum). The
Fast Ethernet ports support full- or half-duplex modes, with automatic MDI/MDIX crossover, and PoE Injector.
The following table shows the RJ45 pin-out assignments for the PoE and Gigabit ports.
RJ45
Pin
10/100BASE-TX
PoE Ports
(Alternative B)
Gigabit
Uplink
Ports
1 RX + BI_DA+
2 RX - BI_DA-
3 TX + BI_DB+
4 Vport+ BI_DC+
5 Vport+ BI_DC-
6 TX - BI_DB-
7 Vport- BI_DD+
8 Vport- BI_DD-