Crown Verity PF-2 User Manual
Page 4
4
INTRODUCTION
GENERAL
Crown Verity Inc. Fryers are produced with quality workmanship and material. Proper installation, usage
and maintenance will result in years of satisfactory performance.
Before using the fryer, thoroughly read this manual and carefully follow all instructions.
This manual is applicable to models listed on the cover page. Procedures in this manual will apply to all
models unless otherwise specified.
WARNING Hot oil and parts can cause burns. Use care when operating, cleaning and servicing
the fryer.
WARNING Spilling hot frying compound can cause severe burns. Do not move the fryer without
draining all frying compound from the tank.
ORDERING PARTS
Customers may order parts directly from Customer Service at 888-505-7240.
To speed up your order, provide the model number, serial number, gas type, part needed, item part
number (if known) and quantity needed.
NOTE: Hoses must be rated min. 140° F. Do not replace hoses, regulators, valves or burners with
other than original equipment. Do not attempt to replace or adjust burners. Contact qualified personnel.
UNPACKING
This fryer was carefully inspected and tested before leaving the factory. Upon acceptance of the
shipment, the transportation company assumes full responsibility for safe delivery.
Immediately after unpacking the fryer, check for possible shipping damage. If the fryer is damaged, save
the packaging material and contact the carrier immediately.
Check that the following have been included:
• Crumb Rack
• Basket Hanger
• Drain Pipe Extension
• Twin Fry Baskets (2)
• Manual and Warranty
Do not use the fryer’s door or its handles to lift the fryer at any time.