D.A.S. Audio Variant Series Systems Guide - Manual (Page 10)

AXC-V112
M8x30 DIN 965
Rubber washer
M8x35 DIN 912
Grower (lock) washer
Metal washer
8
EN
Three different washers must be used along
the M8x35 DIN912 screws and placed in the
following
order- grower (lock) washer, metal
washer and rubber washer.
In order to hang the rest of the boxes the
captive rigging hardware and safety pins will be
used, and the procedures described on the 4.3
paragraph of this manual will be followed. The
picture below shows two
units
hanging from the ceiling.
variant 112A
Before connecting the first box to the ceiling
mount accessory the two M8x30 DIN965 screws
(per side) must be removed from the
and replaced by two M8x35 DIN912.
variant 112A
The units can be set up as a
cluster of more than three enclosures (as explained
above) or as a small array of 2 units. In the latter
case the highly resistant
grid accessory is
not necessary. Instead the ceiling mount
accessory can be used to hang a cluster of up to
four units.
First attach the ceiling mount accessory to the
ceiling or a beam. Before doing so be sure that the
load bearing capability of these elements is
enough. The
will be attached to the
ceiling by means of six nº 10 rawlplugs and six 7
x 40 mm screws.
variant 112A
AX-V25
AXC-V112
AX-V112
variant S uide ystems G