D.A.S. Audio Variant Series Systems Guide - Manual (Page 4)

2
7
8
4
1 2
3
variant 25A - max 20 units
1
2
3
4
variant 112A - max 6 units
EN
Note: The vertical angle between the first
and the flying grid can only be
set up at 0º.
variant 112A AX-V25
The basic procedure to hang the units is as
follows: rotate the connecting links (1) until the
desired angle is reached. Then introduce the
safety pins through the holes labeled with the
desired angle which should have been provided by
the prediction software
(2). Now
introduce the connecting links into the receptacles
of the box above and hang the unit from the
rotating point (3). Finally introduce the safety pin
that secures the unit (4). This procedure will be
repeated as many times as enclosures are to be
assembled. This procedure is also identical in case
of flying
systems.
EASE FOCUS
variant112A
The above described procedure applies to the
rest of the units.
The procedure to mechanically connect the
second unit is similar. First rotate the connecting
links (5) in order to select the correct angle by
means of the safety pins (6). In this example the
selected angle is 2º. Once this has been done then
the enclosure must be hung from the first box (7)
and assured by means of one more safety pin (8).
variant S uide ystems G