D.A.S. Audio Variant Series Systems Guide - Manual (Page 12)

10
System installation using the wall support AXW-V25
M8X30 DIN965
Rubber washer
M8x35 DIN 912
Grower washer
Metal washer
EN
In order to hang the rest of the boxes the
captive rigging hardware and safety pins will be
used, and the procedures described on the 4.3
paragraph of this manual will be followed. The
picture below shows three
units fixed to
the wall.
variant25A
Three different washers must be used along
the M8x35 DIN912 screws and placed in the
following
order- grower (lock) washer, metal
washer and rubber washer.
Warning!! If three units have to be
hung it is advisable to fix the box in the middle to
the wall mount accessory.
variant 25A
Then hang the first unit from the
wall mount accessory. The two M8x30 DIN965
screws have to be removed from each side of the
box and replaced by two M8x35 DIN912 screws.
variant 25A
Up to three units can be wall
mounted by means of the accessory.
First the accessory must be fixed to the wall,
making sure in advance that the work load of the
wall allows for it. The wall mount accessory will be
attached to the wall using six nº 10 rawlplugs and
six 7 x 40 mm screws.
variant 25A
AXW-V25
variant S uide ystems G