CTX Conveyor Oven TCO21140077 - Manual (Page 9)

ENGLISH
9
H. DAILY CLEANING
WARNING
WHEN CLEANING THE OVEN:
• NEVER USE PRESSURIZED WATER.
• NEVER USE A CLEANING SOLUTION OTHER
THAN SOAP AND WATER ON PORTIONS OF THE
OVEN THAT COME INTO CONTACT WITH FOOD
PRODUCTS. THESE AREAS INCLUDE THE
CONVEYOR BELT AND END TRAYS.
• NEVER APPLY ENOUGH LIQUID TO STAND IN
PLACE ON THE OVEN. LIQUID INSIDE THE OVEN
WILL CAUSE A SEVERE ELECTRICAL HAZARD
AND MAY OTHERWISE DAMAGE THE OVEN.
CAUTION
DO NOT clean your oven using abrasive cleaners or pads.
Both will scratch and dull the finish.
1. With the conveyor running, use a brush to clean any
crumbs off the conveyor into the crumb trays.
2. Switch the Power On/Off (I/O) switch to the OFF (“O”)
position, and wait for the cooling fan to turn off.
3. Disconnect electrical power to the oven at the circuit
breaker/fused disconnect.
4. Allow the oven to cool.
CAUTION - HOT
DO NOT TOUCH HOT SURFACES ON THE
OVEN, OR REACH INTO THE COOKING
CHAMBER, UNTIL THE UNIT HAS COOLED
THOROUGHLY.
5. Thoroughly clean the fan grill on the front of the oven
using a stiff nylon brush. See Figure 6.
6. Clean the end trays USING SOAP AND WATER
ONLY and towel them dry. If necessary, the end trays
can be removed for cleaning by removing the screws
that hold them in place. See Figure 2 (in the
Installation section of this Manual).
IMPORTANT
If the end trays are removed for cleaning, they must
be replaced prior to operating the oven.
7. Slide the end crumb trays out from underneath the
entrance and exit ends of the conveyor. See Figure
6.
8. Lift BOTH ends of the center crumb tray; then, slide
the tray out of either end of the oven.
9. Clean all three of the crumb trays using a commercial
oven cleaner. If necessary, towel them dry.
10. Replace the center crumb tray in the oven as shown
in Figure 7.
IMPORTANT
Proper positioning of the center crumb tray is
REQUIRED for proper cooking. Ensure that the tray
is replaced inside the conveyor frame, as shown in
Figure 7, and NOT on the floor of the cooking chamber!
11. Replace the two end crumb trays.
12. Clean the outside of the oven using a damp cloth with
EITHER soap and water OR a stainless steel cleaner.
Use caution to ensure that liquids do not enter the
oven during cleaning, especially when wiping the fan
grill.
Figure 6
End crumb trays and fan grill
Figure 7
Center crumb tray placement
Slide trays straight out
(trays are underneath both
ends of conveyor)
Tray fits
BETWEEN
conveyor belt
and support
tab.
DO NOT
insert tray
on floor of
oven!
Conveyor
belt
Support
tab
Clean fan grill
using stiff
nylon brush