CatEye Q3A - Manual (Page 11)

ENG-10
Before use
Bicycle Installation
Mount the speed sensor and magnet
1-1.Lightly secure the speed sensor
Locate the speed sensor on the left (non-drive
side) chain stay as shown above, and loosely
secure it with the nylon ties.
Do not tighten the nylon ties completely at *
this stage. Once a nylon tie is tightened, it
cannot be pulled out.
1-2.Mount the magnet
Loosen the set screws both on the 1.
SPEED side and CADENCE side of the
speed sensor, and turn the sensor to the
angle as shown on the right.
Temporarily secure the wheel magnet to
2.
the spoke so that it faces the sensor zone
on the SPEED side.
Temporarily secure the cadence magnet in-
3.
side the crank with nylon ties, so that it faces
the sensor zone on the CADENCE side.
Two magnets maybe stuck together inside *
the package, and appear as one magnet.
1
� SPEED
CADENCE
SPEED
� SPEED
CADENCE
Wheel magnet
Cadence magnet
Speed sensor
Nylon ties
Speed sensor
Left chain stay
1. Pre-Install the
wheel magnet
3.Pre-install the
cadence magnet
Nylon ties
2. Set screw on the SPEED side
3. Set screw on the
CADENCE side
Sensor zone
Sensor zone