CatEye Q3A - Manual (Page 15)

ENG-14
Before use
Wristwatch's basic items must be set up before using it.
Removing the insulation sheet
When you use the unit for the first time after purchas-
ing, remove the insulation sheet under the battery.
1
Open the battery cover of the wristwatch
using a coin, etc.
2 Turn the inner cover to the open position
using a coin, remove this, and remove the
insulation sheet under the battery.
Do not turn the inner cover excessively. *
Otherwise, the tab may be damaged.
3 Replace the battery, and turn the inner
cover to the closed position. Check that
the cut-out portion of the inner cover
faces the pin, and the 2 tabs are fixed.
4 Press the AC button beside the inner
cover using a tool with a pointed tip.
5 Check that an o-ring is installed to the
groove on the wristwatch, and firmly
close the battery cover.
Preparing the wristwatch
Restarting
When using the unit for the first time after purchasing, or after replacing batteries,
restart the wristwatch to make it work properly.
The wristwatch and each sensor ID have been checked at the factory. *
Simultaneously press and hold the 1. MENU, SSS, MODE1, and MODE2 buttons
on the wristwatch for about 4 seconds.
“FACTORY DEFAULT” is displayed.
MODE2
MODE1
SSS
MENU
(Simultaneously press)
When “ * FACTORY DEFAULT” is not displayed on the screen, the button op-
eration has not been completed properly. Simultaneously press and hold the
4 buttons again until the display changes.
2. Select “NO”.
When “NO” is displayed on the screen, confirm with the
SSS button.
The backlight of the display lights up and a buzzer sounds,
then the display is switched to the clock/date setting screen.
Proceed to the next set-up item, “Setting the clock/date”.
YES ↔ NO :
MODE2
MODE1
(or) Confirm :
SSS
1
Close
O-ring
AC button
Battery cover
Inner cover
Tab
Pin
Pin
Cut-out portion
CR2430
Open position
Closed position
Insulation sheet
Open
Restarting