CatEye Q3A - Manual (Page 29)

ENG-28
Sports mode
Display data in Sports mode (upper and middle display)
Switch pressing the MODE1 button
Current speed
Displays the current speed in real time. Updates
every second.
Heart rate
Displays the current heart rate in real time.
Updates every second.
Cadence
Displays the current number of pedal rotations
per minute. Updated every second.
Average speed *1
Displays the average speed since the start of
measurement.
Average heart rate
*1*2
Displays the average heart rate since the start of
measurement. The time with no heart rate
measured is not reflected on the average rate.
Average cadence
*1*3
Displays the average cadence since the start of
measurement. Any time with no pedaling is not
reflected on the average cadence.
Maximum speed *4
Displays the maximum speed since the start of
measurement.
Maximum heart rate
*4
Displays the maximum heart rate since the start
of measurement.
Maximum cadence
*4
Displays the maximum cadence since the start of
measurement.
Sea Level Altitude
Displays the sea level altitude at the current loca-
tion point.
Temperature Displays the current temperature.
Ascending altitude
Displays the accumulated altitude from the point
you reset to the current point.
* Any descending altitude is not counted.
Slope angle *6
Displays a ±value on the basis that the slope
angle of 45° is 100%.
*1 Each average value is displayed on the screen replaced with the character “E” when the elapsed
time (TM) exceeds 100 hours. Clear the data by resetting (page 27). The average speed is displayed
in the same way as above when the trip distance exceeds 10000 km [mile].
*2 This device stops calculating the average when the heart rate sensor is detached, and resumes
the calculation when the heart rate sensor is worn again. This feature produces actual averages
with the heart rate sensor worn.
*3 This device calculates the average excluding the time when you stop pedaling. This feature pro-
duces actual averages, unlike other models that calculate averages also to include any zero values.
MODE1
MODE1
(press & hold for 3 sec) (When the measurement is stopped)
Shortcut *5