Ecler ALMA26 - Manual (Page 11)

11
6.2. SAVE PRESET MENU
Once you have edited the active preset or template, the procedure to save the current setup in a
user preset memory is the following one:
 From the main menu, press SHIFT + SAVE
 The SAVE PRESET message is displayed and a preset number is flashing
S A V E P R E S E T
[ P 0 7 ] S T E R E O L I V E 3 W
 Select the user preset using the rotary control, and then select one of the two following
options:
 Press SHIFT + SAVE to validate the selection
Or
 Press SHIFT + CANCEL to cancel the selection and display again the preset from the
selection list
Pressing SHIFT + EXIT at any point during the above process cancels the selection and brings
the main screen back.
If the selection is validated (SHIFT + SAVE) the following screen is displayed, allowing you to
rename the destination preset:
R E N A M E P R E S E T
[ P 0 7 ] S T E R E O L I V E 3 W
To rename the preset:
 Press the right PARAM key to select the first character to edit
 Edit the new character with the rotary control
 Press the left or right PARAM key to select another character to edit
 Edit the new character with the rotary control
 Etc…
 Pressing SHIFT + CANCEL cancels all previous changes, displays the original name and
maintains the edit mode in order to be able to rename the preset again
 Once all the desired characters are edited, confirm the changes by pressing SHIFT +
SAVE, displaying the PRESET SAVED message for a few seconds. The preset is stored
in memory, but is not selected as active preset just by the fact of having been saved
 The main screen returns, showing again the current preset at the time, and it is not
necessarily the newly saved preset
Pressing SHIFT + EXIT at any point during the above process cancels the selection and brings
the main screen back.
The parameters stored in a preset are:
 All the input and output settings, including their names (labels)
 The A and B REMOTE ports setup
 The internal signal generator setup