Canon DR-6010C - Manual (Page 21)

Basic Operation 17
Ch
apte
r 2
(*2) You can scan documents up to 39.2” (1000 mm) long by setting the scanner to the Long document
mode. For details, refer to the User Manual (electrical manual.)
(*3) The paper weights that can be used with the scanner vary depending on the document feed method
(page separation mode or bypass mode.) (See “2-3 Placing Documents,” on p. 22.)
(*4) When the paper is less than 20 lb bond (0.0039") (75 g/m
2
(0.1 mm)) in weight and documents are
3.54" (90 mm) or less in length or 2.36" (60 mm) or less in width, scanning may not perform properly
during continuous feed.
IMPORTANT
A document must meet the following criteria to be scannable:
• When scanning a multiple page document, pages of the same
size, thickness, and weight must be grouped together. Scanning
different sizes and types of paper together can cause the scanner
to jam.
• Scanning documents before the ink is dry can cause problems
with the scanner. Always make sure that the ink on a document is
dry before scanning it.
• Scanning documents that are written in pencil or similar material
have a tendency to make the rollers and scanning glass dirty,
which can lead to smudges in the scanned image and transfer the
dirt to subsequent documents. Always clean the internal parts of
the scanner after scanning such documents. (See “Cleaning the
Sensor Glass and the Rollers,” on p. 35.)
• When scanning a two-sided document that is printed on thin
paper, the image on the opposite side of each page may show
through. In this case, adjust the scanning intensity in the
application software before scanning the document.