Emerson Radio PD6871 - Manual (Page 4)

Battery Operation (Main Unit)
The battery compartment is located on the rear of the unit.
• Remove the battery compartment door by pressing down on the two arrow marks and sliding the door in
the direction of the arrows.
• Insert eight (8) ‘C’ size batteries into the battery compartment as shown below. Be sure to observe the
polarity markings which are engraved inside the battery compartment. If the batteries are inserted
incorrectly, the unit will not operate.
• Replace the battery compartment door.
NOTE: The AC power cord must be disconnected from the AC socket on the back of the unit in order for the
unit to operate on battery power.
4
BATTERY PRECAUTIONS
Follow these precautions when using batteries in this device:
1. Use only the size and type of batteries specified.
2. Be sure to follow the correct polarity when installing the batteries as indicated in the battery compartment.
Reversed batteries may cause damage to the device.
3. Do not mix different types of batteries together (e.g. Alkaline and Carbon-zinc) or old batteries with fresh ones.
4. If the device is not to be used for a long period of time, remove the batteries to prevent damage or injury from
possible battery leakage.
5. Do not try to recharge batteries not intended to be recharged; they can overheat and rupture.
(Follow battery manufacturer’s directions.)
+ + - -
+ + - -
+ + - -
+ + - -
PREPARATION FOR USE (CONTINUED)
Battery Operation (Remote Control)
The battery compartment is located on the rear of the remote
control.
• Remove the battery compartment door by pressing down and
sliding the door in the direction of the arrow.
• Insert two (2) AA size batteries into the battery compartment
as shown to the right. Be sure to observe the polarity markings
which are engraved inside the battery compartment. If the
batteries are inserted incorrectly, the remote control will not
operate.
• Replace the battery compartment door.
+
+
—
—
PD6871.O/M.QXD 4/23/02 10:15 AM Page 4