Emerson Radio MS9923TT - Manual (Page 30)

29
To record from the Turntable:
1.) Press the AUX/PHONO button to the ‘AUX/PHONO’ mode.
2.) Select the part of the record for recording.
3.) Press the RECORD Key on Tape Deck A to start recording.
4.) Press the STOP/EJECT Key and place the tone arm on the rest when finished.
IMPORTANT NOTES: Never try to force the RECORD key. If it will not stay
down, this means that one of the erase prevention tabs on the cassette is
missing.
Refer to ABOUT CASSETTE TAPES on Page 31.
Tape To Tape Recording (Dubbing)
To copy a previously recorded tape:
1.) Press STANDBY (POWER) button to turn system ‘On’.
2.) Press TAPE button. The TAPE Indicator appears in the display.
3.) Press the STOP/EJECT key on both Decks to open the doors.
Insert the pre-recorded tape in Deck B and the blank tape in Deck A with exposed
tape facing down and full reels on the left. Close the cassette doors.
4.) Press the PAUSE key and then the RECORD key on Deck A.
Then press the PLAY key on Deck B. The PAUSE key of Deck A will release
automatically and both tapes will start simultaneously. All the material on the
pre-recorded tape in Deck B will be copied onto the blank tape in Deck A.
Recording Hint: Try to use a blank tape that is the same length or just slightly
longer than your pre-recorded tape. This will enable you to fit all the material
on the copy without excessive ‘blank space’.
High Speed Dubbing
When copying from tape to tape, you can reduce the recording time by pressing
the HI-SPEED DUBBING button to the ‘ On’ position. Both tapes will move at
approximately 2 times the normal speed to cut the recording time in half.
Note:Turn volume down to avoid unpleasant high speed sound.
MS9923TT_B022806.p65 28/2/2006, 9:44 29