Emerson Radio SM51TR - Manual (Page 22)

21
TAPE RECORDING
Tape Dubbing
1. Insert blank cassette tape into DECK A.
2. Insert pre-recorded cassette tape into DECK B.
3. Press the PAUSE button and PLAY button on DECK
B. Then press the RECORD button on DECK A.
Release PAUSE button on DECK A to start tape
dubbing.
NOTE:
To activate High Speed Dubbing, depress the ST./
NOR; MONO./H.S.D. button to
MONO/H.S.D.
position.
6. To stop recording, press the STOP / EJECT button
on DECK A.
Recording from CD
1. Press CD button to select CD function and place
disc in the CD tray.
2. Insert blank cassette tape into DECK A.
3. Press the RECORD button on DECK A to start
recording from CD. The ”REC CD SYNC” indicator
appears on the display and the CD starts playback
at the same time.
4. To stop recording , press the STOP / EJECT button
on DECK A , the CD will change to Pause mode. If
you press the RECORD button again, CD playback
continues automatically.
Recording from TUNER
1. Press TUNER/BAND button to select TUNER
function.
2. Tune to the radio station as described in
LISTENING TO TUNER section that you want to
make recording.
3. Insert blank cassette tape into DECK A.
4. Press the RECORD button on DECK A to start
recording.
NOTE:
High Speed Dubbing does not function during CD or
TUNER recordings.
PLAYING CASSETTE TAPES
3. Depress the STOP / EJECT button of either DECK
A or DECK B to open the cassette door.
4. Insert pre-recorded tape into either DECK A or
DECK B.
5. Push the door back to close.
1. Press POWER button to switch on the system.
2. Pressing TAPE button to select Tape function.
TAPE indicator appears on the display.
NORMAL PLAYBACK ON DECK A or DECK B
1. Press the PLAY button to start playback.
2. Depress the REW button to rewind the tape. Press
STOP / EJECT button to stop at the desired point.
3. Depress the F. FWD button to start fast forward.
Press STOP / EJECT button to stop at the desired
point.
4. Depress the STOP / EJECT button to stop tape
playback. Depress the STOP / EJECT button again
to open the cassette door.
5. You can pause tape playback by pressing the
PAUSE button. Press the same button again to
resume playback.
CONTINUOUS TAPE PLAYBACK
1. Insert pre-recorded tapes into DECK A and DECK
B.
2. Press the PLAY button on DECK B to begin
playback.
3. Press the PAUSE button and then PLAY button on
DECK A.
4. When the tape in DECK B reaches the end. The
PAUSE button on DECK A will release
automatically and playback will begin.
SM51TR.p65 2001/7/3, PM 02:25 21