Emerson Radio CKS2237 - Manual (Page 14)

1 3
WAKE TO BUZZER (Crescendo Alarm)
NOTE: Alarm 1 and Alarm 2 have different buzzer sounds.
• Alarm 1 is a “Single beep” sound.
• Alarm 2 is a “Double beep” sound.
You will be able to tell which alarm is going off by the sound that it makes.
1.) Reconfirm the wake up time and alarm mode settings for the alarm you are
using, Alarm 1, Alarm 2, or both alarms.
2.) Set the ALARM selector switch for one or both alarms to the BUZZER position.
The appropriate ALM 1 and/or ALM 2 indicators will light up to confirm that the
alarms are set.
3.) At the selected wake up time the buzzer will sound. It will begin softly and
gradually increase in volume to wake you up. It will continue for one hour and
then shut off automatically.
4.) To stop the buzzer sooner, press either the appropriate ALM 1 or ALM 2 button.
The buzzer will stop but the alarm remains set and will turn the buzzer on
again at the same time on the following day (depending on the Alarm Mode
setting). To stop the buzzer and turn on the radio immediately, press the RADIO
ON/OFF button instead of the ALM 1 or ALM 2 button.
5.) If you do not want the alarm to turn the buzzer on the following day, set the
appropriate ALARM selector to the “OFF” position.
RADIO AND BUZZER OPERATION
You may also set one alarm for wake to radio and the other for wake to buzzer.
Just set the ALARM 1 and ALARM 2 selector switches to the desired positions.
SNOOZE ALARM
After the radio or buzzer alarm sounds in the morning you may press the
SNOOZE/SLEEP OFF bar for a few more minutes sleep. The respective ALM
indicator will flash.
The alarm will stop for approximately 9 minutes and then turn on again. You may
repeat the Snooze operation up to seven times if desired, but after the seventh
time the alarm will not turn on again.
CKS2237_073106.p65 31/7/2006, 11:11 13