Empress Effects Phaser - Manual (Page 13)

Controls at a Glance
power: 9V - 18V DC negative
tip 2.1mm jack. 120mA or greater
waveform: selects between 8 different waveforms
bypass stompswitch: when the LED is shining, the
phaser effect is applied to the signal. When off, the phaser
is being bypassed (true bypass)
width: determines how far the phase shift varies
from the center position
gain: controls the output gain. The point where unity
gain lies depends on the pedal’s other settings
resonance: selects the amount of feedback applied,
creating resonant peaks in between valleys
expression: selects which knob the expression pedal
will control via the control port
asym
*
these controls are for tap and knob modes. Auto mode uses the controls marked with inverted text. These are outlined in the auto mode section