Empress Effects Phaser - Manual (Page 16)

Universal Control Port
Configuring the Control Port
The control port configuration is set using the dip-switch array
inside the unit. When you open the phaser, you’ll see a set of 3
dip-switches labelled ‘CON JACK CONFIG’. On power up, the
configuration will be changed to the new setting. Here’s a table
of the dip settings for the various configurations:
MODE DIP1 DIP2 DIP3
Expression (default) OFF OFF OFF
Control Voltage ON OFF OFF
External Tap – Latching OFF ON OFF
External Tap – Momentary
(normally open)
OFF OFF ON
External Tap – Momentary
(normally closed)
ON ON OFF
Audio Input ON OFF ON
MIDI OFF ON ON