E-MU PIPEline - Manual (Page 17)

14 Troubleshooting Wireless Features
• Reposition your transmitter or receiver so that there are fewer objects
(for example, multiple walls or large metal structures) between them.
• Make sure your transmitter and receiver are not placed on metal
surfaces.
• Reset the wireless connection. Press and hold the receiver’s Connect
button for five seconds.
• Disconnect the transmitter and receiver from the power source. Then
reconnect them again and reset the wireless connection.
• Check that you have set the Mode DIP switches correctly for your
transceivers. See “Configure your E-MU PIPEline™ units” on page 5.
I need more battery-powered transmit time from my E-MU
Pipeline™ transmitter.
If your battery-powered E-MU PIPEline™ transmitter is running low on
power, simply swap it with your receiver (assuming it is plugged in) and
reverse the R/T DIP switch on each unit. The pairing should remain intact.
I have two transceivers which are configured as transmitters. My
receiver is receiving the incorrect transmission.
Check that you have set the same RF setting for both units in a transmitter-
receiver pair. See “Configure your E-MU PIPEline™ units” on page 5.
EMU Pipeline UG.fm Page 14 Wednesday, March 4, 2009 5:56 PM