Chicago Electric Belt Sander 90045 - Manual (Page 11)

Page 11 For technical questions, please call 1-800-444-3353. SKU 90045
warning! when sanding a 2.
workpiece, always push and pull the
Belt Sander over the workpiece with
both hands firmly gripping the tool.
Do not pass hands or fingers directly
in front of, to the rear, or below the
Sanding Belt (46).
Firmly grip the Belt Sander with both
3.
hands. Then, squeeze the Trigger (66)
to turn on the tool. If desired, use the
Switch Lock to run the Belt Sander in its
continuous mode.
Allow the Sanding Belt (46) to turn up to
4.
full speed before feeding the Sanding
Belt into the workpiece.
To avoid damaging the workpiece,
5.
always sand parallel to the grain of the
wood.
Do not force the Belt Sander to remove
6.
material faster than it is designed to
cut. Push and pull the Sanding Belt
(46) gradually along the surface of the
workpiece.
Once the sanding job is completed,
7.
turn off the Belt Sander and wait until
the Sanding Belt (46) stops turning. To
prevent accidents, make sure the trigger
is released and disconnect the power
supply after use. Clean, then store the
tool indoors out of children’s reach.