Futaba 2PL - Manual (Page 15)

13
Description of 2PL Functions
Steering Dual Rates (D/R-CH1)
Use this function to adjust the steering travel of your model.
If the model understeers (push) while cornering, add steering
by pressing the upper side of the D/R button. When the
model oversteers (loose), take away steering by pressing the
lower side of the D/R button.
Steering Servo Reversing (REV-CH1)
This function reverses the rotation direction of
the Steering servo.
When the trim position deviates from
the center, the deviation will be on the
opposite side when the servo is re-
versed.
30 - 100%
Steering D/R
Model Selection/Model Reset (MDL)
The model selection selects the desired model memory from the 10 model memories
stored within the transmitter and the model reset erases all data stored in a specific model
memory.
Model number
1 - 0
Model name
(Selection key)
Model Selection Model Reset
Push the DT2 lever up or down
for about one second.
All data stored in the current
selected model memory is
erased.
NOR: Normal
REV: Reverse
(Selection key)
Steering Servo Reverse
Throttle Servo Reversing (REV-CH2)
This function reverses the rotation direction of
the throttle servo.
When the trim position deviates from
the center, the deviation will be on the
opposite side when the servo is re-
versed.
NOR: Normal
REV: Reverse
(Selection key)
Throttle Servo Reverse