Futaba 4VF - Manual (Page 17)

USING OTHER FUNCTIONS
USING OTHER FUNCTIONS
USING THE FREQUENCY BOARD
Pass the frequency board over the
small part of the antenna and slide
it to the large part.
1
Stick the band number seal to
the frequency board.
2
Install the frequency board to
the antenna.
*Use side A or side B, depending on the
thickness of the antenna.
Cut off the unused side along the slot with
cutters, etc.
Side A
Frequency board
Band number seal
(after sticking)
Side B
SERVO HORN
Spare servo horns are supplied with the digital proportional R/C set. Use them ac-
cording to the application.
Use the horn set screw supplied
with the servo. If a long screw is used, the interior of the
servo may be damaged.
NON-SLIP ADJUSTABLE LEVER HEAD
The length of the stick lever head can be adjusted.
Lever head A Lever head B
1
Unlock lever heads A and B by
turning them in the arrow direc-
tions.
2
Set the stick to the most com-
fortable length and lock the lever
heads by turning them in the op-
posite direction of the arrows.