Futaba 6YF - Manual (Page 17)

18
U
SING
O
THER
F
UNCTION
U
SING
O
THER
F
UNCTIONS
Using the Frequency Board
1 Stick the band number seal to the
frequency board.
2 Install the frequency board to the
antenna.
Pass the frequency board over the small part of
the antenna and slide it to the large part.
Use side A or side B, depending on the
thickness of the antenna.
Cut off the unused side along the slot with
cutters, etc.
Non-slip Adjustable Lever Head
The length of the stick lever head can be adjusted.
1 Unlock lever heads A and B by turning them in the arrow directions.
2 Set the stick to the most comfortable length and lock the lever heads by
turning them in the opposite direction of the arrows.
Stick Lever Spring Tension Adjustment
The stick spring strength can be adjusted. The operating feel of the aileron, elevator, and
rudder sticks can be individually adjusted.
1 Remove the four transmitter rear case
screws and remove the rear case.
2 Adjust the spring strength by turning the
screw of the channel you want to adjust.
3 Close the rear case and tighten the four
screws.