Futaba 7FGH - Manual (Page 16)

FACTORY REPAIR SERVICE
To insure prompt service, please follow the instructions qiven below.
1. Charge the batteries for at least 1 8 hours prior to shipment
2. Return the system only Not your complete installation Remove the servos from their mounts and remove the foam
padding from the receiver.
3. Plugs or other modifications which interfere with factory test procedures will be returned to factory standard at
your expense.
4. Carefully pack all components individually, using sufficient packing material to prevent damage during shipment.
5. Include a brief but thorough explanation of all problems and service required and tape it to the back of the trans-
mitter Place a label describing the function of the servo on each servo
6. Be sure to Include your full address and tel. Mo.. zip code inside the box as well as on the outside.
7. Include a packing list of all items being returned, and double check to make sure that all items are packed.
8. Upon receipt of your equipment at the Futaba factory, an estimate of the cost of repair (over $25.00 only) will be
sent to you. Your equipment will then be repaired and returned to you upon receipt of payment or C.O.D, (cash).
This factory repair service applies only to the continental U.S.A.. Hawaii, and Alaska.