Futaba 7FGH User Manual

Page 8

Advertising
background image

13 Elevator dual rate switch • Elevator dual

rate ON-OFF switch. Simitar to aileron dual
rate, (dual rate ON) the elevator deflection can

be adjusted with the elevator dual rate trimmer
10 and the servo operating linearity can be

switched with the DR <-> VTR switch 11.

14 Trainer switch Pull on/self-off switch. The

transmitter connected by the trainer cord (M-
TC) operates and when it is OFF, your-own
transmitter only operates.

15 Throttle-rudder mixing knob

Ratchet

knob that sets the throttle to rudder mixing
amount and direction. Mixing amount is 0 —
50%.

16 Idle-up ON-OFF switch This switch is

turned ON when pushed forward.

Throttle servo

Low

High

l7 and the servo operating linearity can be

switched with the DR <-> VTR switch 18 .
Other functions are the same as those of the
aileron dual rate switch.

20 Power switch

2 1 Square level meter Level meter indicates

the transmitter output power and indirectly
shows power supply voltage.

22 Antenna

23 Antenna storage The opening is used for

storage of the antenna while carrying the trans-

mitter. It is located at the bottom right side of

the transmitter.

24 Handle/stand

25 Hook for neck strap

26 Transmitter Ni-Cad

battery charging

jack

27 Trainer cord socket

28 Transmitter RF module

29 Trimmer panel

Non-slip adjustable lever head

The length of the lever head is adjusted to
suit the operator.

Unlock lever head (A) and (B), by turning
them in the arrow direction, set head (A)

to the desired length, then relock the
heads.

6

Idle up amount is adjustable within this

range with the knob 17

Fig. 9

Lever head (A)

Lever head B

17 Idle-up trim control Sets the idling speed

when the 16 idle-up switch is ON.

18 Throttle hold switch When this switch is

set to ON, the throttle servo stops at the posi-
tion set at the 1 2 trimmer and only the pitch
servo operates. This switch is used in auto-rota-
tion dives. Both throttle and pitch servos mix-

ing is performed when this switch if OFF. It is

ON when pushed forward.

19 Rudder dual rate switch Rudder dual

rate ON-OFF switch. Similar to aileron dual
rate, at dual rate ON, the rudder deflection can
be adjusted with the rudder dual rate trimmer

Fig. 10

Inside rear trimmer panel

1,2 Aileron ATV (Adjustable Travel

volume) trimmer [2] RIGHT is for the right

aileron and 1 LEFT is for the left aileron.
The servo travel volume is independently ad-
justable to the left and right from the neutral

position. Travel adjustment ranges 0 to 100%.

Advertising