Futaba GY501 - Manual (Page 41)

42
D
ATA
S
ETTING
Operation Mode Setting
Initial value: CMT
Sets the gyro operation mode. In the "NOR" mode, both G1 and G2
operate in the Normal mode. In the "AVC" mode, both G1 and G2
operate in the AVCS mode. In the "CMT" mode, G1 operates in the
AVCS mode and G2 operates in the Normal mode. In the "Nor"
mode, the GY501 operates the same as conventional gyros. In the
"AVC" mode, the GY501 always operates in the AVCS mode. In the
"CMT" mode, the GY501 can be used in both the AVCS and Normal
modes.
Linkage Limit Setting
Initial value: 100%
Sets the rudder servo travel limit. The linkage limit can be adjusted
by pressing the + and - keys so that the rudder stick is operated and
the servo operates up to the maximum linkage position. When
setting, rudder ATV automatically becomes 200% and the servo
deflection becomes large so that limit setting can be easily per-
formed. A or B is displayed depending on the right or left direction.