Futaba GY701 - Manual (Page 74)

G
OVERNOR
E
XPERT
S
ETTING
74
This sets the details of the governor function for
the expert modeler. Push the mode + or – key
for more than one second on the Governor Basic
menu display, to get into the Governor Expert
menu. Push mode + or – key for more than one
second again on the Governor Expert menu to be
returned to the Governor Basic menu.
(1) Start display
Push mode + or – key, to scroll through the edit-
ing menu. Pushing mode + or – key for more than
one second, brings you back to governor basic
menu.
(2) Governor working mode
default: Governor
This selects the governor working mode as either
governor or revolution limit mode. The Governor
mode works as the engine revolution is at a con-
stant revolution. The revolution limit (Rev. Lmt)
mode only works when the engine revolution ex-
ceeds the setting revolution and engine revolution
is to be lower. Pushing data+ or – key the mode
is changed. When the Rev.Lmt mode is selected,
the menu (6) Throttle data mode should be set to
Tx.Curve mode.