Cisco 12 SP+ - Manual (Page 32)

Chapter 42 Cisco IP Phone Configuration
Configuring Directory Numbers
42-32
Cisco CallManager Administration Guide
78-13310-01
Directory Number Configuration Settings
Table 42-3 describes the fields available on the Directory Number Configuration
Settings pane.
Table 42-3 Directory Number Configuration Settings
Field Description
Directory Number Enter a dialable phone number. Values can include
numeric characters and route pattern wildcards and
special characters except for (.) and (@). The directory
number you enter can appear in more than one partition.
If the words Shared Line appear in red next to the
directory number, the directory number appears on more
than one device in the same partition. Refer to the
“Directory Numbers” section in the Cisco CallManager
System Guide for more information.
Partition Choose the partition to which the directory number
belongs. Make sure the directory number you enter in the
Directory Number field is unique within the partition you
choose.
Voice Message Box Enter the voice mailbox you want to associate with this
line. When a call is forwarded to voice mail, the
Cisco CallManager sends the number you enter here to
your voice-mail application. The voice-mail system then
leaves voice-mail messages in the configured mailbox.
By default, the Cisco CallManager Administration enters
the directory number in this field.
During auto-registration, Cisco CallManager applies the
default mask value you entered in the the Voice Message
Box Mask field on the Cisco CallManager Configuration
pane to this field.
For example, if you enter 97281XXXXX in the Voice
Message Box Mask field and you enter 30000 in the
Voice Message Box field, Cisco CallManager identifies
the voice message box for this directory number as
9728130000.