Cisco 12 SP+ - Manual (Page 4)

Chapter 42 Cisco IP Phone Configuration
Configuring Cisco IP Phones
42-4
Cisco CallManager Administration Guide
78-13310-01
Adding a Phone
Before a Cisco IP phone can be used, you must use this procedure to add the
phone to Cisco CallManager. You can also use this procedure to configure H.323
clients or CTI ports. H.323 clients can be Symbol NetVision phones or Microsoft
NetMeeting clients. CTI ports designate virtual devices used by
Cisco CallManager applications such as Cisco SoftPhone and
Cisco AutoAttendant.
Note If you are planning to use a TAPI application to control CTI port devices using
the Cisco TAPI Service Provider (TSP), then you may only configure one line
per CTI port device.
Procedure
Step 1 Choose Device > Add a Device.
The Add a New Device pane displays.
Step 2 From the Device Type drop-down list box, choose Phone and click Next.
The Add a New Phone pane displays.
Step 3 From the Phone type drop-down list, choose the appropriate phone type
(Cisco IP Phone model, H.323 client, or CTI port) and click Next. Once you
choose a phone type, you cannot modify it.
The Phone Configuration pane displays.
Step 4 Enter the appropriate settings as described in Table 42-1 .
Only the settings appropriate to the chosen phone type appear on your pane.
Step 5 Click Insert.
A message displays stating that the phone has been added to the database.
Step 6 To add a directory number to this phone, click OK and enter the appropriate
settings on the Directory Number Configuration pane as described in the
“Directory Number Configuration Settings” section on page 42-32 . To return to
the Phone Configuration pane, click Cancel.