Haltech E6X Manual Win Version - Manual (Page 153)

E6X Manual
153
E.2.3 2 Hall Effect Sensors
The E6X can be triggered using the output from various Hall Effect sensors. Some OEM
engines as well as aftermarket triggering devices produce the square wave signal the E6X
requires.
Normally a Hall Effect sensor will require at least 3 connections, power, signal and ground.
The power and ground can be sourced from the E6X harness, and the Hall Effect sensor
output signal wire should be connected to the Trigger wire of the E6X (Pin 6 on ECU) or (Pin
B on J:16 Trigger Input for the Terminated Harness). Please note that most Hall Effect
sensors will require the Trigger Pull-up to be switched on in the Trigger Set-up menu.
E6X
ECU
(Pin 6 on ECU) Trigger:
TYPICAL
HALL-EFFECT
SENSOR
+ 12V
0V
Trigger Setup page configuration for Hall Effect Sensor
Hall Effect
Setting
Trigger
Pull-up
Setting