IC Realtime 3Mp Full HD Network PTZ Dome Camera (ICIPP3020HD) - Manual (Page 10)

10
Figure 1-1
1.2.3 Clip wall mount bracket installation
Please connect the flange to the speed dome device. Connect the cable port of the flange to the
slot of the speed dome one by one (It includes power, video, RS485, network cable and alarm
input/output. Please note you can connect the network cable or the alarm input/output if
necessary.). After you connected the flange to the speed dome, please install it to the bracket.
Use the three inner hex screws to secure. See Figure 1-2.
For the corner mount installation or the pole mount installation, you can also refer to these
contents.
Figure 1-2
1.2.4 Address and Baud Rate Setup
Now you can set the IR speed dome address and baud rate. The IR speed dome interface is
shown as below. See Figure 1-3. There are two dial switches: SW1 and SW2. Here you can set
the address, baud rate, communication protocol and etc. Please refer to chapter 1.4 for detailed
information.