IC Realtime 3Mp Full HD Network PTZ Dome Camera (ICIPP3020HD) - Manual (Page 19)

19
4 HANG MOUNT BRACKET INSTALLATION
4.1 Component Installation
Hang mount bracket and its components are shown as below. See Figure 4-1.
Figure 4-1
4.2 Installation
4.2.1 Installation Requirements
The hang mount speed dome can be installed in the hard construction wall in the indoor or
outdoor environments. Before the installation, please make sure:
z The wall is thick enough to install the expansion bolt.
z The wall can at least sustain the 4x weight of the speed dome.
4.2.2 Installation Steps
Loosen the M4 bolt in the flange side to separate the flange and steeve. Pull the integration cable
through the airproof slot of the bottom of the flange and then connect to the centre hole of the
flange. Please secure the flange in the ceiling. See Figure 4-3. Please note, if the speed dome
is installed in the outdoor environments, you need to paste the silica gel on the surface of
the flange and the surface and the cable exit.
Figure 4-2
Figure 4-3
Silica gel
Connect to flange