Interlogix TVC-6120-1 User Manual - Manual (Page 14)

12 TruVision TVC-6110-1 / TVC-6120-1 Camera User Manual
Detect sense: Set the sensitivity level for motion detection. A higher value is
more sensitive.
Block Disp: When enabled, any movement detected will be tracked on-screen.
Press Enter to enable or press the button again to cancel it.
Monitor area: When enabled, a square grid is displayed on-screen. It can only
be enabled if Block Disp is also enabled.
Area Sel: Up to four motion-sensitive areas can be set. Set the size and position
of each one.
Set the privacy mask area
Use this function to mask out selected areas of the image. Up to eight privacy
mask areas can be configured, each by size and location on-screen.
In the Setup menu, go to Motion Det and select the desired parameters.
Area Sel: Up to eight privacy masks can be set. Select a mask and then set its
size and position values using Top, Bottom, Left and Right.
Color: Select the color of the privacy mask.
Transp: Select the transparency shade of the privacy mask. The privacy mask is
fully transparent at value 0.00 and not transparent at 1.00.
Mosaic: Enable this option to see the mask as a mosaic. Default is Off.
Note: Only four privacy mask areas can be set when motion detection is
enabled.