Interlogix TVC-6120-1 User Manual - Manual (Page 6)

4 TruVision TVC-6110-1 / TVC-6120-1 Camera User Manual
Installation
Please check the package contents and make sure that the device in the
package is in good condition and all the assembly parts are included.
To install the camera you will need to prepare the mounting surface, mount the
camera, attach the lens, and make cable connections.
Note: Before installing, please ensure that the mounting surface is strong enough
to withstand three times the weight of the camera. If the mounting surface is not
strong enough, the camera may fall and cause serious damage.
Attach the lens
Refer to the instructions that came with the lens you purchased for complete
installation instructions of that lens.
To attach the lens:
1. Screw the lens clockwise onto the lens mount of the camera.
Note: Please prevent dust from entering between the lens mount and the
lens.
2. For optimal performance, please use an auto iris lens. Plug the auto-iris drive
cable to the 4-pin interface on the side of the camera.
The 4 pins are: 1. Damper -; 2. Damper+; 3. Drive+; 4. Drive-
Connect the cables
To make cable connections:
1. Connect a coaxial cable from the camera’s BNC connector to a CCTV
monitor or video recording device.
2. Connect a 12 VDC or 24 VAC power supply to the power input.