Interlogix UVD-EVRDNR - Manual (Page 10)

Focus adjustment
To adjust the camera zoom and focus, see Figure 5 below and do the following:
1. Loosen the zoom ring thumbscrew.
2. Turn the zoom ring to set the desired zoom.
3. Tighten the zoom ring thumbscrew.
4. Loosen the focus ring thumbscrew.
5. Turn the focus ring to set the desired focus.
6. Tighten the focus ring thumbscrew.
Figure 5: Zoom and focus adjustment
Zoom ring thumbscrew for VA2 and focus ring for VA9 lens Focus ring thumbscrew for VA2 and zooming ring for
VA9 lens
Connect the monitor
Program the cameras by attaching a standard video monitor to the system.
To connect the monitor, do the following:
1. Plug the monitor output cable (Figure 2 on page 5) to the video monitor output
connector (Figure 1 on page 5).
2. Connect the BNC cable to the video monitor.
3. Press Enter (see OSD control pad on page 9) to display the Setup menu.
Programming
This chapter describes how to navigate the programming menus to adjust the
camera settings.
Setup menu
To access the Setup menu (Figure 6 on page 9), do the following:
• To navigate to a menu item, press Up, Down, Left, or Right (Table 1 on page 6).
• To select the item for adjustments, press Enter.
• To display the submenu for the selected item, press Enter.
There is a menu map provided on the back page of the manual.
8 UVD-EVRDNR(-P) Camera User Manual