Interlogix TruVision IP Open Standards Box User Manual - Manual (Page 25)

2BChapter 3: Network and streaming configuring
To define the network parameters:
1. In the “Network Parameters” folder click the Network setting subfolder to
open its screen.
From the NIC Type drop-down list, select the required value. Enter the values
for the IP address, subnet mask, gateway, DNS server and HTTP port. Click
Save
to save changes.
2. Click the
PPPoE setting
subfolder to open its screen and check
Enable
PPPoE
. Enter the user name and password. Click
Save
to save changes.
3. Click the
DDNS setting
subfolder to open its screen and check
Enable
DDNS
. Enter either IP server or DynDNS as protocol.
If DynDNS is selected, enter the user name and password registered to the
DynDNS web site. The domain name is that of the DynDNS web site. Click
Save
to save changes and return to the “Network settings” menu.
4. Click the
E-mail setting
subfolder to open its screen and enter the SMPT
server, SMTP port, user name and password and the e-mail sender and
receiver addresses. Click
Save
to save changes.
Serial port settings
Use the “Serial setting” folder to define the RS-232 and RS-485 communication
settings.
If a PTZ camera is connected to this camera, the RS-485 settings must be the
same as the PTZ protocol used.
TruVision IP Cam Open-Standards User Manual 21