Interlogix TruVision IP Open Standards Outdoor Cameras Installation Manual - Manual (Page 14)

EN 14 Installation Manual
The dome housing has an external
slot.
To mount a TVD-CB5 to a dome:
1. Place the rubber ring on the top
of the dome housing. Ensure that
the slots in the ring and dome are
correctly aligned together to
ensure a proper seal.
2. Attach the CB5 cup base on to
the dome. The final result should
look like this:
Mounting the bullet camera
To mount the camera on a pole:
1. Securely fasten TVD-M-PMA pole mount accessory to the pole at desired
mounting place, with cables prepared near to the camera.
2. Connect a Cat5e cable to the network cable, and connect a 12 VDC power
supply to the power cable.
3. Use TVD-M-PMA enclosed TM4*16mm screws to attach the camera.
4. Adjust the camera position and angle as required.