Interlogix TruVision IP Open Standards Outdoor Cameras Installation Manual - Manual (Page 7)

Installation Manual 7 EN
Figure 2: Outdoor IP bullet camera
Sun shield Mounting bracket
Safety cable Threaded knockout for cable
access
Setting up the camera
Note: If the light source where the camera is installed experiences rapid, wide-
variations in lighting, the camera may not operate as intended.
To quickly put the dome camera into operation:
1. Prepare the mounting surface.
2. Connect the power cable (optional), alarm I/O cables, and network cable to
the camera. See “Connecting the devices” on page 8.
3. Mount the camera to the ceiling using the appropriate fasteners. See
“Mounting the dome camera” on page 9.
4. Set up the camera’s network and streaming parameters so that the camera
can be controlled over the network. For further information, please refer to
the “TruVision IP Camera Configuration Manual”.
5. Program the camera to suit its location. For further information, please refer
to the “TruVision IP Camera Configuration Manual”.
To quickly put the bullet camera into operation:
1. Prepare the mounting surface.
2. Connect the power and network cables to the camera. See “Connecting the
devices” on page 8.
3. Mount the camera to the ceiling using the appropriate fasteners. See
“Mounting a TVD-CB5 to a dome camera” on page 13.
4. Set up the camera’s network and streaming parameters so that the camera
can be controlled over the network. For further information, please refer to
the “TruVision IP Camera Configuration Manual”.
5. Program the camera to suit its location. For further information, please refer
to the “TruVision IP Camera Configuration Manual”.