Interlogix TruVision IP Open Standards Outdoor Cameras Installation Manual - Manual (Page 4)

EN 4 Installation Manual
Features
This section describes the camera features.
 Supports TCP/IP, HTTP, DHCP, DNS, DDNS, RTP/RTSP, PPPoE, SMTP,
NTP, UPnP, ICMP, IGMP, SNMP, FTP, 802.1x, QoS, HTTPS protocols
 Programming and setup through a browser interface
 Live viewing over the network
 50/60 Hz selectable flicker control
 120dB Wide Dynamic Range (WDR models only)
 Motorized lens with zoom function
 Auto focus
 Supports remote upgrades and maintenance
 H.264 video compression with dual capability
 Supports HD (5MPX, 3MPX and 1.3MPX models), VGA,
 IP66 weather proof
 Micro SD card for local storage (dome cameras only)
 Designed to ONVIF and PSIA open standards
Installation
This chapter provides information on how to install the cameras.
Installation environment
When installing your product, consider these factors:
• Electrical: Install electrical wiring carefully. It should be done by qualified
service personnel. Always use a proper PoE switch or a 12 VDC UL listed
Class 2 or CE certified power supply to power the bullet camera, and a
proper PoE / PoE+ switch, a 24 VAC UL listed Class 2, or CE certified
power supply to power the camera. Do not overload the power cord or
adapter.
• Ventilation: Ensure that the location planned for the installation of the
camera is well ventilated.
• Temperature: Do not operate the camera beyond the specified
temperature, humidity or power source ratings. The operating temperature of
the camera is between -10 to +60°C (14 to 140°F). Humidity is below 90%.