Interlogix TVE Series - Manual (Page 20)

16 TVE-400/800-1600 H.264 IP Video Encoder User Manual
Configuring time synchronization manually: Check the Manual Time
Sync box. Click the Select time icon to set the system time from the pop-up
calendar. You can check the checkbox of Sync with local time to synchronize
the time with the local PC.
4. Configure the DST settings, if required.
Check the Enable DST box. Set the start time and end time of DST period.
The end time must be later than the start time. When the DST period ends,
the system reverts to the standard local time. Set the DST bias to 30 min,
60 min, 90 min or 120 min.
5. Click Save to save the settings.
Network set up
You must configure your encoder
’s network settings before using it over the
network.
Table 1: Encoder network functions
Function Description
Basic settings Configure general network settings such as NIC type, IPv4 address,
IPv4 subnet mask, IPv4 default gateway, MAC address and MTU. You
can also configure the DNS server.
PPPoE If the encoder is directly connected to a DSL modem, configure the
PPPoE settings. Contact your ISP to get the user name and password.
DDNS If the encoder is set up to use PPPoE as its default network connection,
configure the Dynamic DNS (DDNS) to be used in conjunction. You
need to register with your ISP before configuring your system for use
with DDNS.
E-mail Configure the encoder to send e-mail notifications of alarms or
notifications through the network.
Note: Ensure that the DNS address has been set up correctly
beforehand.
NetHDD Configure the network disk before operating the recording, playback or log
searching.
SNMP This is an internet-standard protocol for managing devices on IP
networks. Configure this protocol to allow information on the encoder
status as well as event and alarm notifications to be sent to a
surveillance center.
Before configuring this function, you must first install the SNMP
software.
To configure basic settings:
1. Click the Device Configuration > Network Settings > Basic Settings . The
Basic Settings window appears.