Casablanca Fan Company Verrazano 65GxxD - Manual (Page 3)

3
V
ERRAZANO
™
PREPARATION INSTRUCTIONS
Unpacking: Before assembling and installing your ceiling fan, remove all parts from the shipping cartons and check them
against the parts listed here. Before discarding packaging material, be certain that all parts have been removed.
FAN PREPARATION
MOTOR
COUPLING
TAPERED
THREAD
MOTOR
WIRES
GROUND
WIRE
Step B. Using the provided Allen wrench, loosen the Allen
set screw. Thread the downrod into the motor coupling until
it stops turning, this will take at least four and a half full
turns.
Step C. Securely tighten the Allen set screw with the provided
Allen wrench to ensure safe operation of your fan.
CAUTION: Failure to fully lock in the down-
rod before securely tightening the locking
bolt may cause the fan to fall during normal
operation!
IMPORTANT SAFETY INFORMATION!
BEFORE STARTING THE INSTALLATION OF YOUR CEILING FAN, IN-
STALL THE THREADED DOWNROD INTO THE MOTOR COUPLING AND
LOCK THE ASSEMBLY
ALLEN SET
SCREW
DOWNROD
&
BALL
ASSEMBLY
DOWNROD & BALL
ASSEMBLY
PERMA•LOCK™ HARDWARE
Prepare for fan installation as follows:
Step A. Route the wires from the motor through the
Perma•Lock™ downrod and ball assembly, keeping the wires
to one side of the cross pin.
GETTING STARTED
Carton Contents
The fan carton contains the fan body, warranty card, owner’s
manual, and all the parts necessary to assemble and install
your Casablanca ceiling fan. These parts are shown at the
start of each installation section. Before you start, go through
this Owner’s Manual and confi rm that you have all the parts
shown in each section.
Be sure to use only genuine Casablanca blades. The blade
shrink wrap holds 4 blades of matched weight. If more than
one fan is being installed, be sure not to mix blade sets.
GETTING STARTED
Installing a New Ceiling Fixture Outlet Box
If you do not have an existing fi xture located where you wish
to place your Casablanca fan, an approved ceiling fi xture
outlet box must be installed and wired. Using Existing Ceiling Fixture Outlet Box
After turning the power OFF at its source (either circuit
breaker or fuse box), lower the old fi xture and disconnect
the wiring. Check the ceiling fi xture outlet box to be sure
that it is marked “Approved for ceiling fan mounting.” If it is
not, a new box must be installed.
Warning: To reduce the risk of fi re, electrical shock,
or personal injury, mount to outlet box marked ac-
ceptable for ceiling fan support using the mounting
hardware provided with the outlet box.
CAUTION: When removing the shrink wrap,
be careful not to scratch the blades.
NOTE: The fan weight is 37.5 pounds.
REVERSE
SWITCH
NOTE: The downrod has a tapered thread
that is designed to lock completely when
correctly installed.
ALLEN SET SCREW
¼-20 x ¼”
(PRE-INSTALLED)
ALLEN WRENCH