Casablanca Fan Company Verrazano 65GxxD - Manual (Page 8)

8
BLADE
BLADE ROD
BLADE TIP SCREW
(2 PER BLADE)
BLADE HARDWARE
BLADE TIP
Step 10. Remove the shipping cover from
each of the blade rod holders on the fan
body.
Using the provided Allen wrench, unscrew
the blade rod holder screw a few turns
to assure proper installation of the blade
rod. Insert the metal end of the blade rod
(NOT the rubber-tipped end) into the blade
rod holder and tighten the screw fi rmly by
hand.
INSTALL BLADE RODS
Step 11. Attach the blade tips to the blades
using the blade tip screws provided. Using
the screwdriver, tighten securely by hand
only.
BLADE TIP
BLADE TIP INSTALLATION
BLADE
BLADE SCREW
(3 PER BLADE)
BLADE ROD
BLADE ROD
HOLDER SCREW
(PRE-INSTALLED)
SHIPPING
COVER
Note: Do NOT
install the rub-
ber-tipped end
into the blade
rod holder on
the fan body.
BLADE INSTALLATION
Step 12. Insert the blade into the opening
on the side of the fan.
Then insert the rubber-tipped end of the
blade rod into the blade tip slightly.
Next, push the blade rod into the blade tip
until it is tight.
Attach the blades to the interior of the
fan body using the blade screws provided.
Using the screwdriver, tighten securely by
hand only.
BLADE ROD
Note: Be very careful not to
push the blade too far into
the fan as you may scratch
the blade.
CAUTION:
Do not overtighten
screws.
BLADE
SCREWS