iStorage diskAshur Pro SSD Manual - Manual (Page 9)

9
Adding a new User PIN
Deleting the User PINs
You can delete ALL User PINs by doing the following:
1. Enter the Admin Mode ( UNLOCK + 0 for five seconds. Enter Admin PIN and press UNLOCK).
2. Press and hold 7 + 8 + UNLOCK for five seconds until the LED flashes GREEN three
times and then changes to BLUE / RED alternating.
3. Press and hold 7 + 8 + UNLOCK a second time for five seconds until the LED goes on
solid GREEN for two seconds and then back to solid BLUE , this indicates that the User
PINs were deleted successfully.
Changing the User PIN
You can change the User PIN by doing the following:
1. Unlock the drive by inputting your User PIN and pressing the UNLOCK button.
2. Press and hold UNLOCK + 1 until the LED flashes RED .
3. Enter your current PIN and press UNLOCK.
The LED will be Solid BLUE and Solid GREEN .
4. Enter the new PIN and press UNLOCK (The PIN must be a minimum of 7 digits and
a maximum of 16 digits). The LED will flash GREEN three times, then returns to Solid
BLUE and Blinking GREEN .
5. Re-enter the new User PIN and press UNLOCK. The LED stays solid GREEN
indicating that the User PIN has been changed successfully.
1. Enter the Admin Mode ( UNLOCK + 0 for five seconds. Enter Admin PIN and press UNLOCK).
2. Press and hold UNLOCK + 1 until the LED turns to Solid BLUE and Blinking GREEN .
3. Enter a User PIN and press UNLOCK (a minimum of 7 digits and a maximum of 16 digits).
The LED flashes GREEN three times, then returns to Solid BLUE and Blinking GREEN .
4. Re-enter the new User PIN and press UNLOCK. If the LED stays solid GREEN for two
seconds and then solid BLUE , the User PIN was successfully added.