Wire connection, Water connection, Installation checks – Cleveland Range SEL-30-T1 User Manual
Page 4: Cleaning
WIRE CONNECTION
Note: Ensure main power is turned off before connect-
ing wires.
General Information
Install in accordance with local codes and/or the
National Electric Code ANSI/NFPA No. 70-1990 (USA)
or the Canadian Electric Code CSA Standard C22.1
(Canada). A separate fused disconnect switch must be
supplied and installed. The unit must be electrically
grounded by the installer.
The electrical supply must match the power require-
ments specified on the unit's rating label. The copper
wiring must be adequate to carry the required current at
the rated voltage. Wire must be suitable for at least
194°F (90°C). Refer to Specification Sheet for all electri-
cal specifications. Cleveland strongly recommends the
use of liquid tight fittings.
Connection
NOTE: Wiring diagram is located under the top cover of
the unit's right console.
ENSURE THE ELECTRICAL SUPPLY MATCHES THE
UNIT'S REQUIREMENTS AS STATED ON THE ELEC-
TRICAL RATING LABEL.
The supply lines will enter through the bottom of the
right console and are connected to the terminal block.
WATER CONNECTION
(OPTIONAL)
A 1/2" NPT cold water line and/or a 1/2" NPT hot water
line are required if unit is equipped with a single or dou-
ble pantry faucet.
INSTALLATION CHECKS
Although the unit has been thoroughly tested before
leaving the factory, the installer is responsible for ensur-
ing the proper operation of unit once installed.
1. Supply power to the unit by placing the fused dis-
connect switch to the "ON" position.
2. Turn Temperature Dial to 150°F (66°C).
3. Toggle Power Switch to the "ON" position.
4. Heat Indicator Light (yellow) should be ON and unit
heating. When temperature is reached, Yellow
Indicator Light will switch OFF.
7. Turn Temperature Dial 300°F (150°C). Unit will con-
tinue to heat, Heat Indicator Light (yellow) will
remain ON until temperature is reached. Then the
heat indicator light will cycle off indicating the heat-
ing system has shut OFF. The heat indicator light will
continue to cycle ON and OFF as the heating sys-
tem cycles ON and OFF maintaining the desired
temperature.
3. Toggle Power Switch to the "OFF" position.
CLEANING
After installation the unit must be thoroughly cleaned
and sanitized prior to cooking. See “CLEANING
INSTRUCTIONS” in this manual for complete cleaning
instructions.