CDA PC85SC - Manual (Page 3)

4
>
>
>
>
s M O O
ò e M R
>
>
3
Safety Alert Symbols Safety Alert Symbols
Dear Customer
Thank you for using this product. For better understanding of this user
manual and safe use of the product, please make sure the safety messages
following these safe symbols are observed:
Prohibition
A Prohibition symbol indicates actions that are likely to
cause product damage or personal injury and therefore
are prohibited.
A Warning symbol indicates information related to
product safety and personal injury, and instructions
following this symbol should be immediately observed.
A Caution system indicates information related to product
safety and personal injury and instructions following this
symbol should be observed.
Warning
Caution
Safety Precautions Safety Precautions
Power supply: AC 220~240V/50HZ
If the voltage fluctuates violently
(beyond 187~242V), consult a qualified
electrician to prevent startup failure,
damaged control board or
compressor, or unusual noise.
Always pull at the plug and not the
cord itself to disconnect the appliance
from the socket.
Route the power cord in a way to
eliminate the risk of damage caused by
the weight of refrigerator.
Be careful not to damage the power
cord when moving the appliance away
from the wall.
The appliance must be plugged into a
dedicated socket that is earthed
securely.
The power cord of this appliance is fitted
with the three-pin plug (earthed ) that
complies with the standard three-pin
socket . Never cut off or remove
the third prong. The refrigerator should be
located so that the plug is accessible.
WARNING! The plug should be securely
connected to the socket or otherwise it
may cause a fire hazard.
Be careful not to damage the power
cord.
The use of cracked cord or worn plug
is strictly prohibited. If the power cord
is damaged, it should be replaced by
an authorised service engineer .
When the power cord is damaged
If there is a gas leakage
Shut off the gas valve.
Open the doors and windows for
ventilation.
Do not plug or unplug the refrigerator
or other electric appliances.
Unplug the appliance before cleaning
and reparation.
Unplug the appliance before replacing
the old light bulb to prevent electric
shock.
Always remember to unplug
the appliance in the following cases: