CDA PC85SC - Manual (Page 7)

>
2 1
>
1 1
Installing Bottom Trim
Open the door of refrigerator compartment and take out the bottom trim.
Fasten it to the bottom of refrigerator with screws as illustrated.
Wear a pair of gloves to protect your hands when
removing or installing the bottom trim and adjustable
legs of the refrigerator. Installation of legs requires the joint efforts of at least two adults. Don’t
attempt to handle it by yourself. Make sure the appliance is not tilted too
much so that it overbalances.Before moving a refrigerator, the adjustable
legs should be removed to prevent floor damage. NOTE
Installing front cover of delicatessen drawer
Open the door of refrigerator compartment. Take out the front cover of
delicatessen drawer from the crisper cover. Then place the rotary shaft at both
ends of the drawer into the supporting slot of the slide guide, and turn the
front cover of delicatessen drawer down.
Preparation Preparation Preparation Preparation
Installing Legs
Take out the accessory bag containing the legs from the refrigerator
compartment. The appliance should be tilted.by one person and the
legs should be installed as illustrated by the other person.
NOTE
Leg
Reserved
hole
Removing & Replacing Door Handle
Take out the door handles from the refrigerator compartment (2 longer handles
to be installed on the refrigerator and 1 shorter handle to be installed on the
freezer). The following instructions should be observed.
Removing & Replacing Refrigerator Door Handle
Get 2 fasteners out of the accessory bag and place them in 2 reserved holes in
the left door. Install a handle by attaching the reinforcing plate to the fasteners
and then pushing the handle to the left into its place. Install the right handle
in the same way. To remove the handle, push it to the right.
Fastener
Reinforcing
plate