CDA PC85SC - Manual (Page 5)

>
8
> >
>
7
>
>
Remove the door and place it in
a proper position.
Installation
Levelling
The appliance should stand firmly on solid floor. To support it, use firm and solid
pads that are inflammable. Never use the packaging materials for supporting.
Level the appliance with the adjustable legs whenever necessary. Turn clockwise
to raise the refrigerator, and anticlockwise to lower it.
Do not expose the appliance to direct
sunlight or heat source.
Do not expose the appliance to rain and
moisture. Keep the appliance dry and
clean to prevent rust and deterioration of
electric insulation.
To prevent risk of injury and accident, do
not place heavy load and water container
on top of the refrigerator.
10cm minimum
clearance above Distance
10cm minimum clearance at rear
10cm minimum clearance at both sides
Removing & Replacing Door Removing & Replacing Door
NOTE
To avoid injury, property loss or damage to the refrigerator, make sure to
remove all food from door racks and then remove bottle bin(s), unplug the
refrigerator and shut off water supply before removing and replacing a
door.To avoid injury or property loss, remove or replace the door with the
help of 2 persons or more. The following instructions should be observed.Be
careful to prevent the door from falling onto you when lifting the door from the
hinge.To prevent the risk of suffocation, keep children and pets away from
the drawers, in case they may get entrapped in the drawers.
Removing and replacing the right door of refrigerator compartment
Unscrew the upper right hinge cover
by means of screwdriver and then
remove the hinge cover.
Unscrew the upper right hinge by
means of hexagonal screwdriver and
then remove the hinge.
Remove the middle hinge if necessary.
Replace the door in a reverse sequence of removal.
Removing and replacing the left door of refrigerator compartment
Unscrew the upper left hinge cover
by means of screwdriver and then
remove the hinge cover.
Unscrew the upper left hinge by means
of hexagonal screwdriver and then
remove the hinge.
The appliance should be placed in a well
ventilated room. 10cm minimum
clearance at both sides and at rear
is required.