Cypress CDL-160ETH - Manual (Page 9)

7.3 Rear Panel
DC 5V HDMI OUT
EDID
OFF ON
POWER
LINK
① ② ③ ④ ⑤
①
Power: This slot is where user plugs the 5V DC power supply of the unit
before connecting the adaptor to an AC wall outlet.
②
HDMI OUT: The display output port of the converter that is only compatible
with HDMI display.
③
EDID control switch: The default setting of this switch is “ON”.
Leave as it is if the display is properly. If the display has built-in native
EDID, the screen will show display’s resolution and user can selected from
SCREEN RESOLUTION. When switched OFF, the screen will show internal
EDID and user can select from SCREEN RESOLUTION .
Note:
When switch from ON to OFF position, user needs to go to “Launch USB
Server
” to disconnect DisplayLink USB to HDMI and reconnect it
again. If not, the system will remain ON . However, from OFF to ON, the
user does not need to reconnect the DisplayLink USB to HDMI device,
the system will automatically switch to ON mode.(See section 9 for details)
④
LINK LED Indicator: When input switch to MINI USB the blue LED will
illuminate when the source signal is connected. When input switch to
Ethernet a blinking blue LED means its doing signal connection.
⑤
Power LED Indicator: Red LED will illuminate when power is connected to
the converter.
5