Clarion NX501 - Manual (Page 44)

44 NX501/NZ501
English
Owner’
s Manual
16. HD Radio™ RECEIVER OPERATIONS
This function is available when an HD Radio tuner is
connected.
This unit can control the following HD Radio tuner:
• HD Radio Tuner (THD400)
Note:
• Be sure to turn off the ACC power before connecting/
disconnecting the HD Radio tuner.
• Not all areas offer HD Radio broadcasts.
• HD Radio stations may not always broadcast sub
channels
• Volume levels of HD Radio stations may vary. Increase
the volume gradually from the minimal setting after
the channel is selected. Be sure to lower the volume
setting before switching to another mode or channel.
Additional information about HD Radio Technology can
be found at
www.hdradio.com
Listening to HD Radio broadcasts
Note: Connect THD400 HD RadioTM tuner to activate
HD RadioTM function.
1. Touch the [Tuner] button on the Main menu display.
The HD Radio mode screen will be displayed.
2. Press the [FM1/2/3/AM] button or touch the [Band]
key on remote control to select the radio band. Each
time the button is pressed, the radio reception band
changes in the following order: FM1, FM2, FM3, AM,
FM1...
1-Preset Scan Button
2-Direct Button
3-Preset List Button
4-Setting Button
5-Tune Up
6-Tune Down
7-Band Display
8-Bluetooth Status Display
9-System Time
Seek Tuning
1. Press the [FM1/2/3/AM] button to select the radio
band (FM or AM).
2. Touch the [ ] key, and then flick the BIG
Frequency up and down to search for next available
station.
• When flick the frequency up, the station is searched
in the direction of higher frequency.
• When flick the frequency down, the station is
searched in the direction of lower frequency.
Step Tuning
1. Press the [FM1/2/3/AM] button to select the radio
band (FM or AM).
2. Touch the [ ] or [ ] key in frequency panel to tune
up or down by one step.
Recalling a preset station
1. Press the [FM1/2/3/AM] button to select the desire
band (FM or AM) on the tuner.
2. Touch the [ ] key,
3. Press the preset station (1 to 6) on preset list.
4. Press the [ ] key, then press the [ ] button to
auto search and store the stations.
Manual memory
1. Touch the desired Band key to select the band you
wish to store.
2. Tune to a station you want to store using the seek
tuning, step tuning, or preset tuning.
3. Touch and hold the desired Preset key you want to
store for about 3 seconds.
1 3 2
8 9
4
6
5
7
LOC/DX Setting
The DX / LOC setting changes the tuner sensitivity in
order to separate closely spaced stations. This feature
is useful in areas that have many radio stations in close
proximity.
1. Touch the [ ] key to switch to LOCAL tuner
sensitivity.
2. Touch the [ ] key to switch to DX tuner
sensitivity.
NX_NZ501北美版说明书.indd 44 2011-1-19 17:36:28