Crimestopper Security Products CS-2000DPII - Manual (Page 12)

12
OPERATING INSTRUCTIONS
ACTIVE ARMING
To arm the alarm and lock the doors, press the #1
Button (Lock/Unlock Symbol) on the transmitter. You
will hear a single siren chirp and the lights will flash
once. The system will arm, the doors will lock and the
starter will be disabled if these optional features are
installed. After a short 5 second delay to allow vehicle
and electronics to settle, the system will be completely
armed. The alarm status LED in the vehicle will begin
flashing.
ALARM TRIGGERING
If there is an intrusion into the vehicle or hard impact
to the body will sound the alarm and flash the lights
for 45 seconds. After 45 seconds the siren and lights
will stop, but the alarm is still armed to continue to
protect the vehicle. If an intruder left the door open,
the unit will cycle a second time before stopping and then continue to protect the other un-tampered zones of
the vehicle.
DISARMING
To disarm the alarm and unlock the doors, press the #1 Button (Lock/Unlock Symbol) on the transmitter. You
will hear 2 siren chirps and the lights will flash twice. LED stops flashing. Doors will unlock and dome light will
turn on if these optional features are installed.
ALARM TRIGGER RESET
If the armed alarm system is triggered while you are within the range of the remote, pressing the #1 Button will
only shut off the siren and lights while leaving the alarm still in an armed status. To disarm the alarm when it
is in a triggered status, you must press the #1 Button twice.
LOCK /
UNLOCK
AUX. #1
(TRUNK POP)
AUX. #2
Flashlight
Vehicle #2
2 BUTTON REMOTE TRANSMITTER: