Crimestopper Security Products CS-2000DPII - Manual (Page 13)

13
OPERATING INSTRUCTIONS Cont.
REMOTE PANIC PROTECTION
To sound the alarm upon command (panic), press and hold Button #1 for at least 4 seconds until the siren
sounds. Press Button #1 again to reset panic mode.
TRUNK HATCH POP ( REMOTE AUX. OUTPUT 1, OPTIONAL )
To pop the trunk if optional feature is installed ), press Button #2 (Trunk Symbol) on the transmitter for at least
2 seconds. If the system is armed, pressing Button 2 may or may not trip the alarm system when opening the
trunk depending on programming option (10). See page 8.
PRE-WARNING SHOCK PROTECTION & SENSOR ADJUSTMENT
If a low-level shock to the vehicle is detected, pre-warning protection will activate sounding 5 quick siren chirps
and 1 light flash. If a hard impact is detected the shock sensor should trip the alarm system. Once it is
mounted, adjust the sensor as needed by turning the adjustment screw clockwise to increase or counter-
clockwise to decrease the sensitivity. The sensor is also equipped with 2 small indicator lights to ease the
adjustment process. Green light = Pre-warning disturbance (6 siren chirps). Red light = A full alarm trigger.
SILENT ARM/DISARM THROUGH REMOTE ( BUTTON #2 )
This system can be armed and disarmed without siren chirps on an “ as needed ” basis. Press and quickly
release Button #2 ( TRUNK ) to Arm and Disarm system without chirps. NOTE: If Button # 2 is pressed too
long, then trunk pop may activate if optional Trunk pop feature is connected to the system.
PROGRAMMABLE SILENT ARM/DISARM MODE
The system can be silently armed and disarmed as normal with the Lock Unlock Button, without siren chirps.
See alarm programming option #8 on page 8 to enable or disable this feature.
EMERGENCY OVERRIDE & DISARM
If you have lost the transmitter or it stops working for any reason and the Alarm is armed, you will have to
perform and emergency override & disarm to shut the alarm off. Open the door with the key, (alarm will
sound). Turn the ignition on and press the override/program button 4-5 seconds (until siren stops). The Alarm
will disarm. If you continue holding the button (6-7 seconds) the alarm will enter the Valet mode. This allows
you to use the vehicle until you can repair replace the remote transmitter or have the alarm system checked
by an installer.